To get the very best out of your LED lighting solution, in terms of brightness stability and control, the lights should be driven from a current source, not a nominal voltage supply. The Gardasoft pulse / strobe controllers are current sources. The PP420 LED lighting controller offers four output channels which are independently controlled.
Each channel can be individually configured to output continuously; or pulsed based on an external trigger signal or internal timer. The ‘F’ version controller will allow pulse width control down to 1µS resolution. Selected mode allows switching of the light based upon the state of an external trigger.
|Output channels||Four independent constant current outputs with SafeSense™.|
|Output current||From 0mA to 10A in steps of 2.5mA.|
Up to 2A per channel continuous or 10A pulsed.
Total 2A maximum average output current from the controller
|Trigger inputs||4 opto-isolated digital inputs. Require 3V to 24V at 3mA.|
|Pulse width timing||From 20us to 999 milliseconds in steps of 20us.|
Timing repeatability 0.1us
|Delay from trigger to pulse||From 20us to 999 milliseconds in steps of 20us.|
Timing repeatability 1us (depending on conditions)
|Output voltage||0V to 46V|
|Supply voltage||Regulated 12V to 48V. The supply voltage must be at least 1V higher than the output voltage required by the lighting.|
|Dimensions||118mm long by 76mm wide by 27mm high (excluding DIN fixing)|
|Weight||240g excluding DIN fixing|
|Mounting||DIN rail or panel mounting.|