Description
To get the very best out of your LED lighting solution, in terms of brightness stability and control, the lights should be driven from a current source, not a nominal voltage supply. The Gardasoft controllers are current sources. The PP600 LED lighting controller offers two output channels which are independently controlled. Each channel can be individually configured to output continuously; or pulsed based on an external trigger signal or internal timer. The ‘F’ version controller will allow pulse width control down to 5µS resolution. Selected mode allows switching of the light based upon the state of an external trigger. The PP600 also has an additional mode of operation called switched mode. This enables you to very quickly change your light from one intensity setting to another simply by changing the states of the two trigger inputs (high or low). The end result is you can preset up to four different light intensity values and quickly switch from one setting to the next just by changing the states of the trigger inputs.
Product Specification
Parameter | PP612 | |||||||
User interface | Pushbutton & RS232 | |||||||
Lighting connection | Screw terminal & Japanese Style Connector | |||||||
Output channels | Two independent constant current outputs | |||||||
Output current | From 0 to 10A in steps of 0.25mA up to 750mA / Steps of 2.5mA for higher currents Maximum current per channel: 10A pulsed or 4A continuous | |||||||
Trigger inputs | Two opto-isolated digital inputs. Requires 5 – 24v | |||||||
Pulse width timing | From 20uS to 1.3S in steps of 20uS Timing repeatability 2uS | |||||||
Delay from trigger to pulse | From 20uS to 1.3S in steps of 20uS Timing repeatability 2uS | |||||||
Output voltage | 0V to 39V | |||||||
Supply voltage | Regulated 12 – 48v. The supply voltage must be at least 1v higher than the output voltage required by the light | |||||||
Dimensions | 118mm long, 76mm wide, 27mm high (excluding DIN fixing) | |||||||
Mounting | DIN rail or panel mounting. |